C
83
1-19
C
43
C
53
* - C
83
1-18
1-17
1
4
7
9
5
5
6
7
8
3
2
S
A
14
INS
TALLER
US
ER
MAINTEN
AN
CE TECHNI
CI
AN
The kit includes:
N° 1 - Exhaust gasket (1)
N° 1 - Flange seal gasket (2)
N° 1 - Female intake flange (3)
N° 1 - Female drain flange (4)
N° 2 - Bend 90° Ø 80 (5)
N° 1 - Intake terminal Ø 80 (6)
N° 2 - Internal wall sealing plates (7)
N° 1 - External wall sealing plate (8)
N° 1 - Drain pipe Ø 80 (9)
1.13 SEPARATOR KIT INSTALLATION.
Type C configuration, sealed chamber and
fan assisted.
Separator kit Ø 80/80.
This kit allows air to come
in from outside the building and the exhaust to
exit from the chimney, flue or intubated duct
through divided flue exhaust and air intake pipes.
Combustion products are expelled from pipe (S)
(in plastic, so as to resist acid condensate). Air is
taken in through duct (A) for combustion (this
is also in plastic). The intake pipe (A) can be
installed either on the right or left hand side of
the central exhaust pipe (S). Both ducts can be
routed in any direction.
• Kit assembly (Fig. 1-17): install flange (4) on
the central hole of the boiler, positioning gasket
(1) with the circular projections downwards in
contact with the boiler flange, and tighten using
the hex screws with flat tip supplied with the
kit. Remove the flat flange present in the most
external hole and replace it with the flange (3),
positioning the gasket (2) already present in
the boiler and tighten using the supplied self-
threading screws. Fit the male side (smooth) to
the bends (5) in the female side of the flanges (3
and 4). Fit the intake terminal (6) with the male
side (smooth) in the female side of the bend (5)
up to the end stop, ensuring that the internal
and external wall sealing plates are fitted. Fit the
exhaust pipe (9) with the male side (smooth)
to the female side of the bend (5) up to the end
stop; making sure that the internal wall sealing
plate has been fitted, this will ensure sealing and
joining of the elements making up the kit.
• Installation clearances (Fig. 1-18). The mini-
mum installation clearance measurements of
the Ø 80/80 separator terminal kit have been
stated in some limit conditions.
• Extensions for separator kit Ø 80/80. The
maximum vertical straight length (without
bends) that can be used for Ø 80 intake and
exhaust pipes is 41 metres, regardless from
whether they are used for intake or exhaust.
The maximum horizontal straight length (with
bend in suction and in exhaust) that can be
used for Ø 80 intake and exhaust pipes is 36
metres, regardless from whether they are used
for intake or exhaust.
N.B.:
to favour the removal of possible conden-
sate forming in the exhaust pipe, tilt the pipes
towards the boiler with a minimum slope of
1.5% (Fig. 1-19).
* to er complete C
53
configuration also provide for a roof discharge terminal.
Minimum slope 1.5 %
