-15-
REMOTE SENSOR KIT 53900428
This kit may be used on CWR models to sense the temperature at the return air grille.
Item
Qty
Description
1
1
Electronic remote control
2
1
Sensor assembly with 4m lead
3
1
Retaining clip
ISOLATE THE UNIT ELECTRICALLY PRIOR TO INSTALLATION OF THE KIT
1
Fit the retaining clip to the drip tray support bracket, (Fig. 1), with the open end of the clip to the room side of the
bracket.
2
Clip in the sensor with the lead towards the electrics
end of the unit.
3
Route the sensor lead into the electrics box. Use the
plastic cable clamp to secure any spare cable within
the electrics area, ensuring that it cannot foul on the
fan or touch the electric heater (if fitted)
4
Exit the electrics box through one of the cable glands
used for the interconnecting cable and route the lead
to the remote controller position.
NOTE:
The cable may be extended up to a
maximum of 50 metres. Ensure that all joints
and insulation are capable of withstanding
mains voltage.
5
Carefully prise off the push-fit dial on the remote
controller, unscrew the retaining screw and remove
the control cover, (Fig. 2)
Fig. 1.
Fig. 2.
6
Locate the wire link Br.1 in the wall mounted
thermostat, on the right hand side of the white
adjustment potentiometer P1, and cut the link,
(Fig. 3).
7
Locate the sensor, R15, on the left hand side
of the adjustment potentiometer P1, and gently
pull it out of the mounting sockets (Fig. 3).
8
Connect the lead from the remote sensor to
terminals 11 and 12 in the remote controller
Fig. 3.
(Fig. 3).
Heronhill - for all your Airking requirements
Tel: 01823 665660
www.heronhill.co.uk
Fax: 01823 665807
