IMG STAGE LINE LSE-12RG, Instruction Manual

Page: 7 / 12

7
and to a mains socket (230 V/ 50 Hz). The op-
erating mode most recently selected will be
switched on.
3.1 Remote control
Prior to initial operation, remove the protective
film from the battery support so that the battery
has contact to the remote control. When pressing
a button, point the remote control towards the IR
reception LED. When the operating range of the
remote control decreases:
Replacing the battery
1) Push the latch of the battery support to the
right (first arrow) and pull out the support
(second arrow).
1. 2.
2) Remove the discharged battery and insert the
new battery (3 V button cell of type CR 2025)
in the support, positive pole facing upwards.
3) Push the support back into the remote control.
If the remote control is not used for a longer
period of time, remove the battery as a precau-
tion so that the remote control will not be dam-
aged in case the battery should leak.
4 Operation
The laser unit may only be operated by adults.
Never leave the laser unit unattended during
operation.
The laser unit can be most conveniently operated
by means of the remote control:
Button Function
switch on / off
AUTO
automatic sequence and
reset to the initial settings
music-controlled sequence
 II to stop / continue the sequence
Laser color colour: red, green, red + green
Rotating speed to rotate more slowly / faster
Step speed
to rotate step by step:
to reduce / increase the step speed
Flash frequency flashing on, more slowly / faster, off
MIC sensitivity to reduce / increase
microphone sensitivity
The operating mode can also be selected by
means of the button MODE at the unit. The LED
beneath the button will indicate the operating
mode selected:
LED red = automatic sequence
LED green = music-controlled sequence
LED off = laser unit switched off
The power supply unit has a low power con-
sumption even when the laser unit is switched
off; therefore, disconnect the power supply unit
from the mains socket when the laser unit is not
operated for a longer period of time.
5 Specifications
Laser power / wavelength
green laser: . . . . . . . . . . 20 mW/ 532 nm
red laser: . . . . . . . . . . . . 80 mW/ 650 nm
Laser class: . . . . . . . . . . . . . 2M
Beam angle: . . . . . . . . . . . . ±60°
Power supply: . . . . . . . . . . . 5 V (
⎓
) via PSU
supplied and
connected to
230 V/ 50 Hz
Ambient temperature: . . . . 0 – 40 °C
Dimensions w/o bracket
(W × H × D): . . . . . . . . . . . 85 × 45 × 108 mm
Weight: . . . . . . . . . . . . . . . 180 g
Subject to technical modification.
MODE
Laser beam
outlet
IR reception
LED
LED indicates
the operating mode
Bracket for setup/suspension
Locking screw Locking screw
Button for the
operating mode Microphone