19
Order No. 38.0230
BEAM-4/RGBW
6.8 Settings – Sensor
01)
When the display shows
, press the
SETUP
button to enter the sensor settings.
02)
Press the
UP
and
DOWN
buttons to toggle between the following 4 options:
•
p-hall
•
t-hall
•
p-Rast
•
t-Rast
03)
When the display shows
, press the
SETUP
button to view the pan sensor state.
04)
If there are not any errors, the display will show
.
05)
When the display shows
, press the
SETUP
button to view the tilt sensor state.
06)
If there are not any errors, the display will show
.
07)
When the display shows
, press the
SETUP
button to enter the pan correction menu.
08)
Press the
UP
and
DOWN
buttons to toggle between the 2 options:
•
p-Sets
•
p-State
09)
When the display shows
, press the
SETUP
button to enter the menu.
10)
Press the
UP
and
DOWN
buttons to enable or disable the pan correction.
If enabled, the device will reset the pan position to its default setting, whenever there is any
deviation from it.
11)
When the display shows
, press the
SETUP
button to enter the menu.
12)
Press the
UP
and
DOWN
buttons to toggle between the 2 options:
•
history (general number of the corrections performed on the device)
•
current (number of corrections performed on the device since it has been switched on)
13)
Press the
SETUP
button to reset both, history and current status.
14)
When the display shows
, press the
SETUP
button to run the reset, or the
MODE
button to
cancel the reset.
15)
Repeatedly press the
MODE
button to return to step 7 and press the
UP
and
DOWN
buttons until the
display shows
.
16)
Press the
SETUP
button to enter the tilt correction menu.
17)
Press the
UP
and
DOWN
buttons to toggle between the 2 options:
•
t-Sets
•
t-State
18)
When the display shows
, press the
SETUP
button to enter the menu.
19)
Press the
UP
and
DOWN
buttons to enable or disable the tilt correction.
If enabled, the device will reset the tilt position to its default setting, whenever there is any deviation
from it.
20)
When the display shows
, press the
SETUP
button to enter the menu.
21)
Press the
UP
and
DOWN
buttons to toggle between the 2 options:
•
history (general number of the corrections performed on the device)
•
current (number of corrections performed on the device since it has been switched on)
22)
Press the
SETUP
button to reset both, history and current status.
23)
When the display shows
, press the
SETUP
button to run the reset, or the
MODE
button to
cancel the reset.
6.9 Settings – About
01)
Repeatedly press the
MODE
button to return to step 1 and press the
UP
and
DOWN
buttons until the
display shows
.
02)
Press the
SETUP
button to enter the menu.
03)
Repeatedly press the
UP
and
DOWN
buttons to view the current versions of the LED, engine, software
and model.
