Imetec N4001, Operating Instructions Manual

Page: 16 / 82

14
en
SYMbOLS
Attention Prohibited
ON/OFF button Corrosive substances hazard
DescripTion oF appliance anD accessories
refer to Figure [A] in the ILLUSTrATIvE GUIDE to check the contents of the package.
1. Handle
2. Fastening screw
3. Charging contact
4. Plug
5. Multi-surface brush
6. Suction inlet
7. Dust collection system
7A. Dust collection compartment
7B. Filter protection mesh
7C. Filter
7D. MAX Level
8. Dust collection compartment lever
9. Technical data
10. Electronic power control
11. ON/OFF switch
12. Battery status LED
13. Battery cover
14. Battery pack
ASSEMbLY
• Loosen the fastening screw (2) of the handle and remove it.
• Attach the handle (1) to the body of the appliance, taking care to assemble it correctly.
• Insert the fastening screw (2) and tighten it clockwise with the aid of a screwdriver [Fig.
B1].
• Attach the brush (5) to the suction connection (6) [Fig. C1].
ACCESSORIES
Your appliance is equipped with the following attachments:
• MULTI-SURFACE BRUSH: suitable for all surfaces: ceramic, marble, parquet and rugs.
preparaTion
aTTenTion!
only use the original battery charger supplied with the appliance.
Do noT charge the appliance with temperatures lower than 0° and higher
than 45°.
before using the appliance for the first time, the battery must be completely
charged.
noTe: The product must be set in a stable position while charging.
charging The baTTerY
• Make sure the appliance is set to OFF before recharging it.
• Fit the feeder (4) into the recharge contact (3) [Fig. D1].
• Connect the plug (4) to the socket.