12
EN
ASSEMBLY
• loosen the fastening screw (3) of the handle (1) and remove it.
• attach the handle (1) to the body of the appliance, taking care to assemble it correctly.
• Insert the fastening screw (3) and tighten it clockwise [Fig. B1].
• Connect the multisurface brush (10) to the suction inlet (11).
ACCESSORIES
Your appliance is provided with the following accessories:
Multisurface brush (10): the multisurface brush (10) can be used on all surfaces: ceramic,
marble, wooden floors.
USE
• Turn the upper cable hook (2a) downwards [FIG. C1].
• Fully unwind the power cable (4).
WARNING! DO NOT use this appliance if there are visible
signs of damage.
WARNING! DO NOT use this applaince to vacuum:
• burning ashes, cigarette butts, etc.;
• liquids, such as carpet cleaners;
• sharp or hard objects, such as nails or large glass shards;
• fine powder, such as cement;
• toner powder (for laser printers, copy machines, etc.).
NOTE: Using the vacuum cleaner with the cable fully or partly wound involves an
overheating hazard!
NOTE:
1. Bear in mind that a new appliance can develop odours the first few times it is
used. These odours are harmless and disappear shortly afterwards. Ventilate
the room.
2. Transparent parts can become opaque, due to use.
Insert the plug into the socket, while holding the appliance by the handle to prevent it from falling in the
event that it was not stored in the OFF position.
Press the ON/OFF button (10) once to switch the vacuum cleaner ON or OFF (7) [Fig. d1]:
• switch the appliance off after use, by pressing the ON-OFF button (7) and disconnect
the plug from the socket.
• Wind the cable (4) round the two hooks (2a and 2B) [Fig. C1].