IMET SIRIO 315 User Instructions Download

Page: 20 / 41

TRADUCTION OF THE ORIGINAL INSTRUCTIONS FOR USE

S315 SH eng ED.2011 rev.00

18/41

- 15.1 -- CUTTING SETTING
Place the vice in the position tou need by lever

–pos.2/dr.RI0322- Open jaws an put the material inside the vice and

place it rightly as regards to the cutting line.
Be sure that the handle-pos.1/dr.RI0322 locks the rotation of the work table.
Lock the workpiece between the jaws ( by lowering a little the handle-pos.7/dr.RI0324- in the models which have the
pneumatic vice ).

– MANUAL MODEL

Select the cutting speed with the control -pos.2/dr.RI0324-, close the cooling cock and turn on the the main switch-
pos1/dr.RI0324- Never change the speed during cutting work and wait until the blade do not turn.
Adjust the coolant flow and start the cutting by lowering handle; by this machine cutting efforts are very light because
the handle has a special device that reduce effectivecut stroke.

If this handle-pos.7/dr.RI0324 is in inconvenient

position, please pull it on the outside to unhook it from the joint and wheel the handle until your choseen
position. Put the handle into the joint again to lift up or to lower the gear head

We advise you to lower the coverblade guard so that it covers the blade much more. Loosen the 2 screws placed on
its side and place the coverblade guard down/up.
Don’t forget: : place the coverblade guard to the possible upper position when you change the cutting limits.

It is possibler to adjust the lenght also of the stroke that must be made for the cutting :
loosen the two screws -pos.8 and 9/dr.RI0324- that serves as mechanical stop and move them along the little round
cavity, depending on the needs.

SEMIAUTOMATIC MODEL
ADJUSTABLE WORKING STROKE :
SELECT THE BLADE SPEED AND SELECT THE PUMP SWITCH TO 0 (OFF).
BLOCK THE MATERIAL IN THE VICE NEAR TO THE BLADE EDGE ( do not across the blade line).
CLOSE THE  DOWNSPEED REGULATOR AND PRESS WHITE START BUTTON TO START THE CYCLE .
ADJUST THE DOWNSPEED OF DESCENT UNTIL THE  BLADE REACHES ABOUT 10 MM ABOVE THE MATERIAL
AND BLOCK IT AGAIN.

SLIDE THE LOWER REGISTER UNTIL YOU PRESS THE CORRESPONDING LIMIT SWITCH, THEN BLOCK IT
INTO POSITION .
REOPEN THE  REGULATOR IN ORDER TO REACH  THE POSITION OF THE END CUT AND BLOCK-DOWN
AGAIN THE DESCENT.
PLACE THE UPPER REGISTER AGAINST THE CORRESPONDING ELECTRIC LIMIT SWITCH: In these conditions
the saw head cames back to the top , TO THE POINT OF BEGINNING.

AFTER THE CUTTING LIMITS ARE SETTED:
SELECT BLADE SPEED (AND PUMP COOLANT FUNCTIONING)
MOVE THE MATERIAL IN THE CUTTING /FACING POSITION AND BLOCK IT.
P.S: EVEN IF THE THE VISE CLOSES AUTOMATICALLY 5 mm IN CASE THE CYCLE IS STARTED BEFORE
BLOCKING THE PIECE, EVERYTIME YOU CHECK THIS CONDITION.

CLOSE THE SPEED REGULATOR AND START THE CUTTING CYCLE .
ADJUST DESCENT SPEED WHILE CUTTING.
AT THE END OF THE CUT THE HEAD BACK UP QUICKLY AND THEN THE VICE CAN BE REOPENED.

15.2 - - STOP DEVICE / EMERGENCY STOP
In every moment it is possible to stop the cycle:

by the main switch - the machine stops immediately.

By the emergency mushroom button

In case of electric energy interruption the sectionalising switch switches-off ( at 0 position) and it is necessary to
restore it for use the machine again.

Lower cutting limit

Upper cutting limit