IMET SIRIO 315, User Instructions

Page: 17 / 41

TRADUCTION OF THE ORIGINAL INSTRUCTIONS FOR USE
S315 SH eng ED.2011 rev.00 15/41
The structure of this machine is complying to the protection requirements of the EEC Directives 2006/42/EEC, in terms
of Electromagnetic Compatibility (E.M.C.).
In particular it respects the technical prescriptions of the norms EN 55011 and EN 50082-2, and it is foreseen to be
used in industrial enviroments and in residential ones also.
- 13 -- MACHINE SETTING FOR STARTING
Verify that the machine has not clear damages or faults and check upon the standard equipment including the tools ,
fittings to carry out some adjustments, using and maintenance handbook.
In case the machine is supplied with additional equipment make sure that they aer adaptable to the machine.
Point in good time the possible damages or faults to the reseller or to the service staff before the starting machine.
Remove the protective sustances put on the surfaces during the moving and transit by using a non-filamentous cloth
or paper, please check that there is no rust on the metallic parts.
In case of using compressed air jet always wear proper eye protection.
Only for Manual model : loosen the screws that lock the cutting limits -pos. 8 and 9/dr. RI0324- ( on the right side
near the control lever).
Take out the inside chip tray by unhooking it from the guides and remove the possible dirty or objects that can obstruct
the passage of the coolant.
The parts in motion ( guides, trolleys, pivots, bearing support, bearing disc etc.) are already lubricated, the reducer gear
has got the oil necessary to the operation.
The possible pneumatic installation is ready to start; anywhere check if it is made by the indication of INSTALLATION
paragraph.
13.1 - COOLING AND LUBRICATION PLANT