IMET B014, Technical Manual, Page: 13 / 25

TECHNICAL MANUAL
Page n°13 of 25
RF TRANSCEIVER MODULE 2.4GHz
B014
Doc. Revision°:0
Date: 11/01/2021
Technical Manual file.dot revisione n° 0 data: 24/02/2020
IMET s.r.l.
Via Ronche, 93 33077 Sacile (PN) – ITALY – Tel. (+39) 04347878 – Fax (+39) 0434 737848 P.IVA C.F. e Reg. Impr. PN:01106390931 R.E.A.
43483 CCIAA PN http//www.imet.eu e-mail: info@imet.eu
4.1 PIN Description table
PIN Symbol Type Description
JM16 PWDN LDO Power enable; Power ON / Power OFF the RF module
JM63 GND Ground Ground
JM17 VREG Power
/ANALOG Power supply output from internal switching
JM7 CREP DI Reserved for internal used
JM55 BACKLIGHT ANALOG Reserved for internal used
JM14 DATA -RX DI UART Serial communication data input
JM13 DATA-TX DO UART Serial communication data output
JM15 CFA-REQ DI Digital input for frequency change request
JM38 PSTF DI
/ANALOG Reserved for internal used
JM43 VBATT IN ANALOG Battery voltage signal
JM40 XC DI Reserved for internal used
JM41 PWR_UP_EN DI Reserved for internal used (keep the switching power supply ac-
tive)
JM52 +VCC_A ANALOG Regulated voltage output at 3.3V
JM53 +VCC_B ANALOG Regulated voltage output at 3.3V
JM64 GND Ground Ground
– JTMS JTAG Test mode select
– RESET Reset Microcontroller Reset PIN
– JTCK JTAG JTAG signal
– JTDO JTAG JTAG signal
– VCC_A 3.3V Power supply for microcontroller during programming phase
DO = Digital Output ; DI = Digital Input; GPIO = general porpouse input / output
Table 3