E190601X rev.6_ENG
May 30, 2022
34
Any ordinary or extraordinary maintenance must be carried out by professionally qualified personnel. Make sure
all power supplies are disconnected before performing any type of maintenance.
Ordinary and extraordinary maintenance are reported to follow with the expected cadences.
EVERY DAY
-
The machine must be kept clean using neutral detergents. Clean the bodywork in order to eliminate any trace
of soap, and so also the detergent tray.
-
Clean the gaskets of the porthole.
-
Clean vents and vents
-
Check the cleaning condition of the basket: make sure that there are no deposits.
-
Check that the drain valve does not lose
-
At the end of the day, leave the porthole open to ventilate the interior
-
At the end of the day disconnect all energy and water supplies
-
Clean the air panel filters
-
EVERY THREE MONTHS
-
Check that valves, pipes and gaskets do not lose
-
Check the goodness of the drive belts and cleaning conditions of the basket: make sure that there are no
deposits.
-
Check the cleanliness of the drain valve
-
Check the cleanliness of the loading valves and their filters
EVERY YEAR
An authorized technical assistance center shall be consulted for:
-
Perform the cleaning of the inside of the machine
-
Check the goodness of the electrical contacts of the wiring
-
Check the tightness and integrity of rubber parts
-
Perform greasing of mechanical parts that require it
-
Clean the engine vents
ATTENTION!
In the case of tilting machines, before starting any maintenance, make sure that the air circuit is completely
exhausted and no movements of the pneumatic drives can occur, even in the absence of power supply.
In the case of maintenance in non-resting positions of some drives, be sure to mechanically and safely lock all
pneumatic drives.
34. WASHING PROBLEMS
If there are poor results in the washed tissues, check the following table.
PROBLEM detected
Probable SOLUTION
The fabrics still come out dripping with water.
Verify that the program ends with a final centrifuge.
It is possible that a series of imbalances have occurred:
check the load and relaunch a centrifuge.
Fabrics come out with obvious marks of the
basket
Check the spin speed, it is probably excessive.
The fabrics come out felted.
Check the labels of the garments and compliance for use
in the washing machine.
Check centrifuge speed and temperatures of the cycle
used.
