Imax B6 Ultimate, Instruction Manual

Page: 11 / 24

T o a v o i d f r o m e r r o n e o u s s e t t i n g b y
users,B6 detects the cell count of Lithium
battery automatically at the beginning of
charge or discharge process. But battery
that is deep-discharged can't be detected
correctly. To avoid this error, the time term
can be set to verify the cell count by the
processor. Normally, 15 seconds are
enough to detect the cell count correctly.
You need to extend the time term limit for
the battery of large capacity. But the
charge or discharge process may come to
an end within the time term because of the
time limit decided by the wrong count if
you set too long time limit for the battery of
small capacity. This may cause fatal error.
You have to extend the time term if the
processor detect the cell count incorrectly
at the beginning of charge or discharge
process. Otherwise, default value is
recommended to use.
T h i s s h o w s t h e t r i g g e r v o l t a g e f o r
automatical charge termination of NiMH
and NiCd battery. The valid value ranges
from 5 to 20 mV per cell. Setting the
trigger voltage higher brings a danger of
overcharging; whereas setting it lower
b r i n g s a p o s s i b i l i t y o f p r e m a t u r e
termination. Please refer to the technical
s p e c i f i c a t i o n o f t h e b a t t e r y . ( N i C d
default:12mV, NiMH default:7mV)
LiFe
V.Type 3.3V LiFe
V.Type 3.3V
LiPo/LiIo/LiFe
CHK Time 10 min
NiMH Sensitivity
D.Peak Default
NiCd Sensitivity
D.Peak Default
NiCd Sensitivity
D.Peak Default
NiCd Sensitivity
D.Peak Default
LiFe
V.Type 3.3V LiFe
V.Type 3.3V
LiPo/LiIo/LiFe
CHK Time 10 min
NiMH Sensitivity
D.Peak Default
NiCd Sensitivity
D.Peak Default
USB/Temp Select
Temp Cut-Off 80C
USB/Temp Select
USB Enabled
INC
INC
INC
INC
INC
INC
INC
INC
INC INC
DEC
DEC
DEC
DEC
DEC
DEC
DEC
DEC
DEC DEC
-
-
-
-
- -
+
+
+
+
+ +
As default this charger will be set to typical user settings when it is
connected to a 12V battery for the first time. The screen displays the
following information in sequence and the user can change the
parameter on each screen.
If you need to alter the parameter value in the program, press
Start/Enter key to make it blink then change the value with INC
or DEC key. The value will be stored by pressing Start/Enter key
once.
The screen shows the nominal voltage of
Lithium battery. There are three kinds of
Lithium battery: LiFe(3.3V), Lilo(3.6V) or
LiPo(3.7V). This information is of critical
importance that you have to check the
battery carefully to make sure it is set up
correctly. If it is different from correct
value, explosion can occur during charge
process.