Imax B6 Ultimate, Instruction Manual

Page: 12 / 24

There is a 3-pin port on the left of the charger used as USB interface or
temperature sensor port. If the screen displays temperature, you can use
the optional temperature probe to connect to the surface of the battery. If it
is set as the USB port, you can connect the charger to your PC through the
optional USB cable to monitor the charging process through optional
software.
The maximum temperature of the battery can be set during the charge
process. The process will be terminated automatically to protect battery
once the temperature of battery reaches this value. This feature is
accomplished through temperature probe (optional).
INC
INC
INC
INC
INC
INC
INC
INC
INC
INC
INC
INC
INC
DEC
DEC
DEC
DEC
DEC
DEC
DEC
DEC
DEC
DEC
DEC
DEC
DEC
-
-
-
-
-
-
-
-
+
+
+
+
+
+
+
+
LiFe
V.Type 3.3V
LiFe
V.Type 3.3V
LiFe
V.Type 3.3V
LiFe
V.Type 3.3V
LiFe
V.Type 3.3V
Waste time
CHG/DCHG 5min
Key Beep ON
Buzzer ON
Input power low
Cut-Off 10.0V
Capacity Cut-Off
ON 5000mAh
Safety timer
ON 120min
The battery becomes warm after
cycles of charge/discharge process.
The program will insert a time delay
after each charge/discharge process
to allow the battery enough time to
cool down before beginning next
cycle of charge/discharge process.
The valid value ranges from 1 to 60
minutes.
When the charge process starts, the
integrated safety timer starts to run
simultaneously. If error detected or
the termination circuit can not detect
whether the battery is fully charged or
not, this unit is programmed to
prevent overcharging. Please refer to
the below statement to calculate the
timer you set.
T h e p r o g r a m p r o v i d e s m a x i m u m
capacity protection function. If the
D e l t a - p e a k v o l t a g e c a n n o t b e
detected or the safety timer times out,
t h e c h a r g e p r o c e s s w i l l s t o p
a u t o m a t i c a l l y , w h e n t h e b a t t e r y
r e a c h e s t h e u s e r - s e t m a x i m u m
charge capacity,
The beep to confirm users' operation
s o u n d s e v e r y t i m e a b u t t o n i s
pressed. The beep or melody sounds
at various times during operation to
c o n f i r m d i f f e r e n t m o d e c h a n g e .
These functions can be switched on
or off.
This function monitors the voltage of
the input battery used to power this
charger. If the voltage is lower than
user-set value, the program will end
forcibly to protect the input battery.