18
21
1
2
3
4
5
6
"-" appears on the copy quantity/
magnification display in the operation
section of the copier for approximately
13 seconds. Then, copier drive starts and
the remaining time before drive ends is
counted down on the copy quantity/
magnification display (245 seconds).
When copying is enabled, "1" appears
and the Start indicator lights up.
IMPORTANT!
Do not turn the power off or open
covers while the copier is driving.
Doing so may cause printing problems
or contaminate the copier internally.
Press the drawer bottom
plate down and lock it there.
Holding the width
adjustment lever, move it to
align the width guide with
the required paper width.
Paper sizes are marked inside
the drawer.
While squeezing the tabs on
the sides, remove the length
guide and then insert it into
the holes of the required
paper length.
Paper sizes are marked inside
the drawer.
*If the paper touches the right-hand
wall of the drawer, the length guide is
not used. Store it in the space shown
in the illustration.
IMPORTANT
• Load paper so that it is kept under
the claw of the drawer.
• When loading the paper into the
drawer, make sure that the copy side is
facing up (the copy side is the side
facing up when the package is
opened).
Set the paper flush against the
left-hand wall of the drawer.
Gently push the drawer back in.
• Check that the paper is kept
under the claw of the drawer.
If not, reload the paper.
19
Close the covers and drawer.
Connect the power cord.
22
Turn the main switch on.
20
For DL155 copiers only.
Attach the original holder to the
left side of the copier.
Install the waste toner tank.
*Do NOT remove the tape.
If the waste toner tank is not
installed correctly, the front cover
will not close.
Load Paper.
Pull the drawer out as far as it
will go. If an optional drawer is
installed, do not pull more than
one drawer out at a time.
* Check that the length and width
guides securely contact the paper.
If there is a gap, adjust the
position of the length or width
guide to close it.
* Load paper all at once and do
not add paper until all sheets are
used up. if you add paper to a
drawer that still contains paper, a
paper misfeed may occur.
Installation is complete!
The copier is ready for normal copying.
• For details on how to load paper,
see "1. how to load paper" on
page 3-1 in the User's Manual.
15
16
17
From the separate package,
remove the Printpowder®
toner container and waste
toner tank.
CAUTION
Do not incinerate toner
and toner cartridges.
Dangerous sparks may cause burns.
Hold the toner container
vertically and tap the top 15
times. Turn the container upside-
down and tap the top 15 times.
Then, hold the container
horizontally and shake it from
side to side 10 times.
Install the toner container.
First insert the toner container
into the copier as far as it will go
and then slide it to the right as
indicated by the marked arrows.
PN: DL1800110
Imagistics International Inc.
100 Oakview Dr.
Trumbull, CT 06611
www.Imagistics.com
