Installation
VTM-2400 Installation and Operation Handbook
7
Connecting the VTM-2400
The back panel connectors are illustrated in
Figure 2-2
, and the function of each connector is
described in
Table 2-2
.
Figure 2-2. VTM-2400 Back Panel Connectors
Table 2-2. Description of Back Panel Connectors
Key
Label
Description
1
REF
Female BNC connectors that connect to an external reference signal
(NTSC/PAL video, blackburst, or tri-level) from which the horizontal and
vertical sync for the VTM-2400 will be derived if EXT has been selected as
the REF source. If these connectors are not looped through, then the
unused connector must be terminated at 75
Ω.
2
ANALOG AUDIO
IN/OUT
Optional 37-pin, D-sub, male connector for analog audio inputs and outputs.
The supplied breakout board can be used for solderless connections.*
3
DIGITAL AUDIO INPUT
1, 2, 3, 4
Optional female BNC connectors for AES/EBU audio input.
4
SDI INPUTS A (IN,
OUT), B (IN, OUT)
Female BNC looping HD or SD SDI input and output connector. Termination
required.
5
REMOTE
RJ11 socket to connect to the remote control panel.*
6
VFlash
RJ45, female, 10/100BaseT Ethernet connection to be used with a PC
running the VFlash program.*
7
XGA OUT
15-pin, high-density, female, D-sub connector for XGA output.*
8
LTC/GPI
15-pin, high-density, female, D-sub connector for LTC, and GPI input.*
*See Appendix B, “Pinouts,” for the connections.
Ethernet Setup
1.
Prior to the VTM-2400 Network configuration, obtain Transmission Control
Protocol/Internet Protocol (TCP/IP) addresses from the System Administrator or from the
Internet Service Provider (ISP).
