Imagine Selenio 6800 HUC6801+D, Installation And Operation Manual

Page: 23 / 62

11
Copyright © 2010, Harris Corporation
3
Configuration and Operation
Overview
This chapter describes how to operate the HUC6801
+
D using card-edge controls or
CCS-enabled software and hardware controls.
The following topics are discussed in this chapter:
„
Operating Notes on page 11
„
Changing Parameter Settings on page 12
„
Configuring Video Input Settings on page 14
„
Configuring Video Input Settings on page 14
„
Configuring Aspect Ratio Conversion on page 19
„
Configuring Audio on page 23
Operating
Notes
When setting the control parameters on the HUC6801
+
D, observe the following:
„
If you make changes to certain parameters, other related parameters may also be
affected.
„
When you change a parameter, the effect is immediate. However, the module requires
up to 20 seconds to save the latest change. After 20 seconds, the new settings are
saved and will be restored if the module loses power and must be restarted.
„
For proper operation, the output HD standard frame rate should match or double the
reference standard frame rate.
„
The manufacturer recommends that you terminate any unused coaxial output
connectors with a 75-
Ω
connector.
Re-clocking SD-HD Signals
In a normal upconversion operation, the D module conform to all specifications
set out in this manual. However, if you use re-lock output 1 (labeled
RCLK SD/HD OUT 1 ) to
re-lock an HD-SDI signal (which puts the module into Bypass mode), the Return Loss
specification is typically 12 dB to 1.485 GHz.