Chapter 3
Configuration and Operation
12
Copyright © 2010, Harris Corporation
Q-SEE Compliant Thumbnails
The HUC6801
+
D supports Q-SEE compliant thumbnails. To use Q-SEE compliant features,
you must install the modules in an QXFE frame or an FR6802
+
QXF frame
that also
contains a 6800
+
ETH module. When you open a
Control
window in CCS Pilot or Navigator
for the 6800
+
ETH module, all Q-SEE compliant modules provide thumbnails on a
Video
Streaming
tab. In addition, the HUC6801
+
D module
Control
windows have a
Streaming
tab where a thumbnail is displayed and updated at up to three frames per second.
Q-SEE-compliant thumbnails are available for all inputs, but only one can be viewed at a
time. The following standards are supported:
SD-SDI 525
SD-SDI 625
1080i/29
1080i/25
1080p/23
720p/59
720p/50
Note:
For more information on Q-SEE compliant thumbnails, see your FR6802
+
QXF or
QXFE Frames Installation and Operation Manual.
Changing Parameter Settings
You can change parameter settings for this product at the card-edge, or you can use CCS
software and hardware controls.
Card-Edge Controls
1
Rotate the mode select rotary switch (hex switch) to “0.”
2
Once the hex switch is set to “0,” toggle the navigation switch up or down to select a bank.
View the three control LEDs next to the navigation toggle switch to see which bank is
currently selected..
Table 3-1
Bank Select LEDs
Bank
Number
Bank 0 LED
(first top LED)
Bank 1 LED
(second top LED)
Bank 2 LED
(third top LED)
0
Off
Off
Off
1
On
Off
Off
2
Off
On
Off
3
On
On
Off
4
Off
Off
On
5
On
Off
On
Summary of Contents for Selenio 6800 HUC6801+D
