Imagine neo adc-3981, Installation And Operation Manual

Page: 42 / 63

28 ADC-3981 Installation and Operation Manual
Chapter 3: Operation
Enabling or Disabling an Alarm Parameter
To enable or disable an alarm parameter, follow these steps:
1. Select
Alarms , then select Config , and then press Enter .
2. Select one of the alarm parameters, and then press Enter .
3. Press Enabled or Disabled .
4. Press Enter to activate the selection.
Restoring Default Settings
To restore the alarms to their default settings, follow these steps:
1. Select
Alarms , select Config , and then press Enter .
2. Scroll down the list of alarms, and then select Reset.
3. Press Enter to activate the selection.
The following table lists the default alarms for the ADC-3981 module.
You can enable or disable these settings, but you cannot change the
level of the alarm.
State Recovery Parameter Availability
The parameter settings for this module are automatically saved onto the
3901RES-E resource module installed in your NEO frame every five
minutes. If a module should fail and be replaced with a cold spare, the
state parameters can be automatically recovered. For more information
on this feature, see the
NEO FR-3901, FR-3903, and FR-3923
Mounting Frames Installation and Operation Manual (Edition E and
above).
Table 3-3. ADC-3981 Default Alarms
Card-Edge
Alarm ID
Name of Alarm
Alarm
Level
Meaning of Alarm
DARSPrsnt DARS Present Major Loss of DARS reference
DARSRefErr DARS Reference Error Minor Error in the DARS reference signal
GlVPrsnt Genlock Video Present Major Loss of genlock video reference
GlLocked Genlock Locked Major Loss of locked reference