DA-S/SR/H/HR6802
+
DL Installation and Operation Manual
5
Copyright © 2009, Harris Corporation
Preliminary—Contents are proprietary and confidential. Do not photocopy or distribute.
Chapter 2
Installation and Operation
Installation Procedures
Caution
Before installing this product, read the
6800
+
Series Safety Instructions
and Standards
manual shipped with every host frame installation and
operation manual, or downloadable from our website. This safety
manual contains important information about the safe installation and
operation of 6800
+
series products.
Unpacking the Module
Review
“Unpacking/Shipping Information” on page vii
before you install
DA-S/SR/H/HR6802
+
DL modules.
Setting Jumpers
You need to configure modules for local or remote operation
before
power-up.
You can use the J1 jumper to select local control reclock setting or to select
remote control operation. See
Figure 2-1
for a close-up view of the J1 jumper
set.
Table 2-2 on page 9
shows the possible local reclocking mode parameters.
Follow this procedure to set the jumpers:
1. Locate the J1 jumper set on the module.
2. Place a shunt on the pin that corresponds to the mode that you want.
Summary of Contents for DA-H6802+DL
Page 4: ......
