OP
+
OER Installation and Operation Manual
15
Copyright © 2010, Harris Corporation
Chapter 2: Installation and Operation
Inspection and Cleaning Procedure
Inspection
To inspect and clean the fibers, follow these steps:
1. Ensure the fiber is not “live.”
WARNING
Eye damage may occur if an optical instrument such as a
microscope, magnifying glass, or eye loupe is used to stare at an
energized fiber end.
2. Inspect the fiber endface with a fiberscope.
3. If the fiber endface is clean, return to the installation instructions on
page 10
for back modules,
or
page 11
for front modules.
If the connector is dirty, proceed to the dry cleaning instructions
below.
Dry Cleaning
If you are using cartridge or pocket-style dry cleaning tools, follow the
manufacturer’s directions. If you are using lint-free wipes, follow these
steps:
1. Fold the lint-free wipe four to eight times into a square, taking care
to avoid touching the cleaning surface of the wipe.
2. Lightly wipe the fiber tip in the central portion of the lint-free wipe.
CAUTION
Do not scrub the fiber. Excessive rubbing will leave scratches.
3. Repeat the wiping action on another clean section of the wipe or a
new wipe.
4. Inspect the connector again with the fiberscope.
5. If the connection is clean, return to the installation steps on
page 10
for back modules, or
page 11
for front modules.
If the connector is still dirty, proceed to the wet cleaning
instructions.
