9
4. Remove the two warning decals (not shown) from
the spa shell. Wipe out the spa shell using a damp
cloth. Before you fill the spa, make sure that it is in
the desired position and that it can easily be ser-
viced. Once the spa is filled with water, it must be
drained before it can be moved.
Using a garden hose or other clean water source,
begin filling the spa.
Do not use soft water.
You
may fill the spa with cool water; however, if you use
warm or hot water, the spa will be ready to use
sooner. Fill the spa until the water is about four
inches (10 cm) below the console.
Do not overfill
the spa.
5. Place the Spa Cover (18) over the Spa Unit (15).
Make sure that the Spa Cover is centered.
Snap a Buckle (2) onto each of the four latches on
the Spa Cover (18).
Pull down one of the straps on the Spa Cover (18)
and hold the Buckle (2) against the side of the Spa
Unit (15). (Note: To position the Buckle correctly,
have a second person hold the strap on the opposite
side of the Spa Cover tight.)
The Spa Cover must
be tight. Do not place the Buckle over the
grooves between the wood panels.
Refer to the
inset drawing. Remove the latch from the Buckle (2).
Attach the Buckle to the wood panel with two Buckle
Screws (1).
Note: It may be helpful to use a drill
with a 1/16” bit to make starter holes in the wood
panel. It may also be helpful to apply a little soap
or wax to the screw threads.
Attach the other three Buckles (2) to the wood panels
in the same way.
Remove the Spa Cover (18) from the Spa Unit (15).
Before using the spa, carefully read USING THE
HYDROTHERAPY SPA beginning on page 11.
Fill to Here
4
5
18
15
15
2
Strap
2
1
Strap
Latch
6. Before using the spa, follow the instructions on page 10 to post the included warning sign.
Do not allow the
spa to be used before the warning sign is posted.
3. The hydrotherapy spa is designed to operate with either a 120 volt or a 240 volt power source. For your con-
venience, it comes factory wired to accept a 120 volt power source.
The spa must be wired by a licensed,
qualified electrician directly to an approved Ground Fault Circuit Interrupter (GFCI) in compliance
with all local, state, and national electrical codes.
Before you have the spa wired, be sure that it is in the
position you want, and that it can easily be serviced, if needed. For information on converting your spa to
240 volt operation see CONVERTING THE SPA TO A 240 VOLT POWER SOURCE on page 18.
