7
3. Attach a Wheel (45) to each side of the Base
(48) with a Wheel Bolt (40), two Wheel Spacers
(44), and a Nut (47) as shown.
Do not over-
tighten the Wheel Bolts; the Wheels should
turn freely.
48
45
47
44
44
40
45
44
44
40
47
3
2. Orient the Left Upright (31) as shown, and attach
it to the Base (48) with two Upright Bolts (40) and
two Upright Star Washers (39);
do not tighten
the Upright Bolts yet.
48
31
39
39
40
Latch
Holes
2
4. Turn the Base (48) over, and set it near the front
of the treadmill as shown.
Cut the tie holding the Upright Wire (28) in a bun-
dle.
Wrap the wire tie in the Right Upright (36)
around the end of the Upright Wire (28). Then,
pull the other end of the wire tie until the Wire
Harness is extending from the upper end of the
Right Upright. Secure the Upright Wire to the top
of the Right Upright so that it will not fall inside.
Raise the Uprights (31, 36) so the Base (48) is
flat on the floor.
Make sure that the end of the
Upright Wire (28) does not fall into the Right
Upright.
4
Wire
Tie
28
28
Wire Tie
48
28
36
31
Large
Hole
