ILVE 645SNHSW-BRZ, Use And Maintenance

Page: 34 / 44

34
The instructions below are intended for the skilled technician who will install the
cooker, regulate it and perform technical maintenance and who will ensure that
these operations are carried out in the most correct way possible, in compliance
with the regulations in force.
Important
: the cooker must be disconnected from the electric socket before per-
forming all regulating or maintenance operations.
This appliance complies with the following directives
DIRECTIVE 2002/96/CE
LOW TENSION DIRECTIVE 2014/35/EU
ELECTROMAGNETIC COMPATIBILITY DIRECTIVE 2014/30/EU
REGULATION No. 1935/2004 (contact with foods)
The installation must be done in a workmanlike manner and in full compliance
with the regulations in force concerning electrical installation. Otherwise the ma-
nufacturer declines all responsibility. In this booklet you will also find the wiring
diagram of your appliance.
The appliances are designed to be connected to the voltage shown on the data
plate.
Before connecting the appliance to the mains, make sure that:
• The characteristics of the electromagnetic switch or of the socket can with-
stand the load of the equipment (see data on the plate);
• The power supply system must have an effective earth connection.
The appliance is supplied with a cable without plug: the connection must be
made taking into account that the yellow-green cable is the earth conductor
and must never be interrupted.
The socket must be visible and reachable so that you can easily disconnect the
appliance.
For direct connection to the network, it is necessary that:
• The limiting valve and the domestic system can bear the load of the equip-
ment (see serial number plate);
• The power supply system is equipped with an effective ground connection;
• The socket or omnipolar switch, with a minimum opening of 3 mm, is easily
accessible once the appliance has been installed;
• A landline disconnect switch is incorporated in accordance with the installa-
tion rules.
The yellow-green earth conductor must never be interrupted even by the swi-
tch. The power supply cable must be positioned so that it does not come into
contact with surfaces that have a temperature higher than 50 ° C above the
environment. If it is necessary to replace the power supply cable, contact the
assistance service.
INSTALLATION
Electrical connection
Installation rules