Operation
6 Operation
6.1 Control
panel
1
VALUE:
VALUE: 4 digit 7 segment LED display – Pressure value, parameter value
2
STATE:
4 digit 7 segment LED display – Mode, operating mode, type of parameter
3
mbar:
Luminous spot = identification of the unit of measurement mbar
(factory setting)
4
torr:
Luminous spot = identification of the unit of measurement Torr
5
psi:
Luminous spot = identification of the unit of measurement psi
6
UP:
arrow key
changes values (upwards)
7
OK:
setting level – selection of the parameters to be set – activation of the setting values
Transfer of temporary values into the memory during operation
8
DOWN:
arrow key
changes values (downwards)
9
START:
activation of a procedure
10
AIR:
Venting
11
STOP:
end of a procedure
12
P min
Reduction of the pressure to a minimum
13
ON/OFF
Separate switch off of the controller
Fig. 6 Control panel
6.1.1 Starting
up
The Vacuum Controller is switched on by the rocker switch
POWER
located on the device.
The device is ready for operation after a short initializing routine, during which a signal tone
sounds and all light elements light up briefly.
18 113184
