Installation
9
Adjusting angle of the camera
Adjust the angle of the camera by changing the heading direction by reference to the following pictures
Adjusting zoom and focus IPL02B1BNWIY & IPL02B2BNWIY
Your camera is supported with motorized zoom and focus. Thus, connecting the device to a network is
pre-requisite to enable the adjustment of zoom and focus. For the network connection, refer to the
section, Network Connection and Configuration
in this manual.
Once the device is on the network and the webpage is open, go to
Setup
>
Video
>
Zoom/Focus
.
Then, the features shown below will appear.
1. Adjust zoom and focus by clicking the arrow buttons. The buttons
move the lens more
A. Loosen the joint(
③
) with the hex wrench driver, and
rotate the camera bracket 180 degrees if the bracket was
fixed for wall mount(image on the left).
Then, tighten the joint(
③
).
B. Loosen the joint(
②)
to ideally adjust the tilt angle of the
camera, and tighten it if the angle is appropriate.
C. Adjust the angle delicately if necessary after the
installation on the ceiling.
①
②
A. Loosen the joint(
②
) with the hex wrench driver to
adjust the tilt angle of the camera for wall mount.
B. Adjust the angle delicately by loosening the joint(
①
)
if necessary after the installation on the wall.
Model Shown:
ADCi610-M022
Wall Mount
Ceiling Mount
