Installation
8
Quick Start Guide
Installation
1. Place the paper mounting template that is included in
the package on the desired installation surface.
2. Drill three holes in the correct positions based on the
paper mounting template, and insert the plastic anchors
into the holes.
3.
Attach the silicon waterproof band included in the
package to the camera’s mounting surface by aligning it
with the three alignment holes on the camera
’s mounting
surface.
4. Connect the required cables to the device. Refer to
Connections
in this manual for more details.
5. Place the camera body on the mounting surface to
match its alignment holes with the corresponding plastic
anchors.
6. Tighten the plastic anchors with the screws through the
camera
’s alignment holes.
7. Adjust the heading direction of the camera. Refer to the
section,
‘Adjusting angle of the camera’ for more details.
8. Attach the lens cover to the camera by rotating it
clockwise.
9. Adjust zoom and focus of the camera. Refer to the
section,
‘Adjusting zoom and focus’ in this manual for the
instructions.
Model Shown IPL02B2BNWIY
CAUTION
Sealing gaps is recommended as gaps may appear after the camera installation. Gaps may cause
problems such as moisture, water leakage, and etc., which negatively affect the operation of the
camera if gaps appear but remain unsealed.
CAUTION
To prevent products from damage, place the camera on stable and non-vibrating surfaces If the
stability is in doubt, consult safety personnel for reinforcements, and then proceed with the installation.
