18
Illusonic
IAP
Chapter 3
Usage
Other Settings
A number of other settings are available for each preset.
Name
You can customize each preset’s name.
Rotary (Push)
toggles between
the letters and
Rotary (Turn)
selects a specific letter or blank.
IMMERSIVE AUDIO
SHOW/HIDE
HIDE PRESET 1
IMMERSIVE AUDIO
BASS MGMT
OFF
IMMERSIVE AUDIO
EQUALIZER
ON
IMMERSIVE AUDIO
GAIN/DEL TRIM
ON
OTHER SETTINGS
NAME
MUSIC
Gain/Delay Trim, Equalizer, Bass Management
For each preset, you can switch each of these functions On or Off. Note that
Low and High Pass Filters stay active even when Equalizer is Off, i.e. crossover
filters stay always active (except during measurement with IAP Calibration).
Show/Hide
You can change the show/hide status for each preset and so change the
number of available presets. Select one of the presets with
Rotary
and tog-
gles between show and hide with
Select
.
3.4
Ad Hoc Settings
Press
Menu
to enter Ad Hoc Settings. These settings are temporary, i.e. changes
will be reset when restarting IAP.
TONE CONTROL
ROOM 2
-10 dB
TONE CONTROL
ROOM 1
MUTE
TONE CONTROL
SUB GAIN
-3 dB
TONE CONTROL
CENTER GAIN
1 dB
TONE CONTROL
SUBSONIC FILTER
30 Hz DEFAULT
AD HOC SETTINGS
BALANCE
LEFT 1 DEGREE
AD HOC SETTINGS
DSP INFO
96 kHz FMT: 0 DSP: 58/62
CALIBRATED
PHONO
-40.0 dB
Press Menu
DSP Info
This menu shows DSP related information, such as sampling rate, input for-
mat (HDMI), and DSP load/peak-load.
Balance
Left-right balance can be modified by shifting stereo input phantom center to
left or right.
Subsonic Filter
A subsonic filter is globally defined in IAP’s outputs configuration. Here the
subsonic filter can be changed or switched On/Off temporarily.
Gains
When using center or subwoofers, their gains can be modified.
Room Mute and Volume
When IAP is used with several rooms, each room can be set to mute and its
relative volume can be changed.
