Commissioning
Part 1
Activate commissioning (or linking) mode
for a system compatible with the switch.
If you don’t know how to do this, consult the
manual for the compatible system or contact
the manufacturer for assistance.
Part 2
Put the switch into commissioning mode.
To enter commissioning mode, start by selecting
one button on the switch. (Use the same button
for the entire sequence. Pressing any other
button will exit the commissioning mode.)
Next, execute the following long-short-long
sequence:
1. Press and hold the selected button for
more than 7 seconds before releasing it
2. Press the selected button quickly
(hold for less than 2 seconds)
3. Press and hold the selected button again
for more than 7 seconds before releasing it
The switch has now entered commissioning
mode.
Channel ID
Lower
Frequency
Center
Frequency
Upper
Frequency
11
2404
2405
2406
12
2409
2410
2411
13
2414
2415
2516
14
2419
2420
2421
15
2424
2425
2426
16
2429
2430
2431
17
2434
2435
2436
18
2439
2440
2441
19
2444
2445
2446
20
2449
2450
2451
21
2454
2455
2456
22
2459
2460
2461
23
2464
2465
2466
24
2469
2479
2471
25
2474
2475
2476
26
2479
2480
2481
Part 3
Linking the switch to the compatible system.
A radio signal needs to be sent from the switch
to the compatible system on the correct ZigBee
channel. The system uses one of sixteen possible
channels, automatically set by the system. Using
the switch, a signal will be sent on each channel
until the channel used by the compatible system is
found.
Upon entering commissioning mode, the switch
sends a signal on the currently selected channel.
The signal is sent on the default channel 11, unless
the switch had been put on another channel
previously. (This allows linking additional devices
without changing the currently used radio channel.)
Here is a chart of the ZigBee channels and the
corresponding radio frequencies (in MHz).
AHD0612B
Lindon, UT• www.ILLUMRA.com • 801-349-1200
Cycle through the sixteen channels
To change the switch’s channel, short press
the selected switch button (less than 7
seconds) once
after entering commissioning
mode. This will reset the channel used by the
switch to channel 11.
If the switch was already operating on
channel 11 (default condition) then the
radio channel will remain unchanged. This
ensures that the switch will always use
channel 11 as the starting point for the
channel adjustment.
Short press the selected button (less than 7
seconds) again to move to the next channel.
For each such button press, the switch transmits
on the next channel. If channel 26 has been
reached then channel 11 will be used next.
When the switch is on the correct channel,
the compatible system will provide a
link confirmation indication.
Consult the
instructions for the compatible system for
details of the link confirmation indication.
There should be a visible or audible exchange
indicated on the system, and the switch will be
linked to the system.
Exit linking mode on the switch by pressing
any other button on the switch.
Once the linking process is complete, work
with the compatible system to define the
behavior of individual buttons on the switch.
For problems with the compatible system,
please contact to the system provider.
