ILGI TXS 20, Users Manual & Spare Parts List

Page: 20 / 30

20
6. POSSIBLE FAILURES AND TROUBLESHOOTING
FAILURE CAUSE TROUBLESHOOTING
The machine lean towards
right or left Front and rear disc groups
may be operating at
different work depths Make the adjustment of the
machine front rear parallelism at
the upper connection of the
tractor
Front and rear batteries
operate at different
working depths Front rear parallelism
adjustment was not done The chassis parallelism
adjustment must be made at
stretcher lever attached to axle
and arrow
The wheels are swaying
and rotating under
strained * There’s congestion in the
bearings, adequate
lubrication wasn’t done
* Broken cracking at hub
bearings Bearings are examined by
detaching the hub, deformed
ones replaced. Lubrication is
made.
Hydraulic system doesn’t
lift * Oil is reduced in tractor
hydraulic oil reservoir
* Leakage may be in the
hydraulic circuit
* Hydraulic cylinder felt
may be burst. * Hydraulic oil level must be
checked
* Entire hydraulic circuit must be
checked, the leakages must be
repaired.
* Hydraulic cylinders must be
checked by detaching.
The discs are rotating
hardly in free condition or
not rotating * There’s congestion in the
bearings, adequate
lubrication wasn’t done
* The bearing was
deformed or broken * The grease fittings are replaced
by detaching if the bearings not
getting enough oil, and pumped
oil again by removing oil plug.
* If necessary bearings are
checked by detaching the
bearings, replaced if necessary,
gathered again after cleaning.
* Broken and cracked parts are
replaced.
The machine can’t provide
the required working
depth. * The characteristic of the
soil may be hard.
* Disc diameters are
shrunk due to normal
wear. * The discs are replaced as a set if
there’s too much wear by
measuring the discs (wear time
may vary depending on the
cultivated soil characteristic)