Tilt Adjustment
You may need to raise the front of the projector in order to get all of
the picture on to the screen. This is done by rotating the two front
feet (6) until the correct adjustment is obtained.
It is not a good idea to tilt the projector too much because this
will give a slightly distorted picture. The best way to avoid this is
to place the projector on a higher support.
Adjusting the Mirror
In order to get maximum screen brightness it may be necessary to
adjust the mirror.
Insert the special card provided into the magazine and bring it
into the projection position by means of the autochange lever.
Remove the lens and observe the image of the filament wires on a
screen or card about 6 inches in front of the projector.
The wires of the filament should be seen with an inverted secondary
image in the position shown in the diagram. If this is not the case,
the mirror should be adjusted by moving the lever (8) which is situated
underneath the projector.
Replace the lens and the projector is ready for use.
This is how the image of the
filament will appear when the
mirror is correctly adjusted.
7
