Ilex Filtration Biodrum 20 +31384447366
4
Subject to typesetting and printing errors
2.3
The customer must immediately and thoroughly
inspect the goods upon delivery. (Apparent /
possible) damage must be reported immediately in
writing. Hidden defects must be reported
immediately upon discovery. The customer is
responsible to report transport damage to the
carrier and / or to Ma-koi within 24 hours.
Failure
to timely check and report transport damage can
lead to loss of warranty.
2.4
Ma-koi is not liable for the consequences of
incorrect application, use, maintenance and / or
operation of the product by the customer, nor for
normal wear and tear. This applies in particular to
the consequences of thermal, chemical,
electrochemical or electrical influences and also for
not following our user guide. The same applies to
damage resulting from changes or modifications to
the product that have not been approved by Ma-koi
in advance.
2.5
In principle, the customer is responsible for damage
directly attributed to the incorrect use of the product.
If the customer returns the product, break-proof
packaging should be used. The customer is liable for
any damage that can be attributed to inappropriate
packaging.
2.6
Claims against Ma-koi expire within a year after the
initial delivery of the goods to the customer. The same
applies to damage claims, regardless of their legal
cause. The limitation period does not apply to claims
based on the malicious concealment of damage, injury
to life, body or health or any other damage resulting
from intent or wanton negligence.
2.7
If it becomes apparent during our examination of
damage reported by the customer or in the course
of repairing defects that the reported damage or
claims were made wantonly or were unwarranted,
Ma-koi may charge for inspecting and repairing
defects. The customer has the right to reject a
necessary repair and to demand the return of the
filter. In general, every inspection of damage is
bound to lump sum compensation if it appears that
the customer is responsible for the damage.
2.8 Replacement parts
Our liability to deliver and stock spare parts is limited to
the period of 5 years after initial shipment of the
product. For spare parts the prices apply as stated on
the website www.Ma-koi.com.
2.9
Subject to alterations
The manufacturer is entitled to change the product at
any time without prior notice being required,
as long as these changes improve the reliability or
quality of the product. No claims can be made if, for
example, the design, functionality or performance of
the filter fundamentally changes. The confirmed filter
specifications are always guaranteed.
3.
General
3.1
Description of the drum filter
The Drumfilter consists of a drum sieve that is driven
by an electric motor. Control electronics and a waste
pump are also supplied. The drum filter has the job of
filtering and discharging suspended substances, dirt
particles and algae residue
This drum filter is a product that can only be used in
fresh water. The filter has been designed for use with
ponds.
The water to be filtered flows (by gravity or through
a pump) into the inlets in the drum. On the inside of
the drum, the dirt remains behind because of the
mesh that is stretched over the drum. As the mesh
becomes dirtier, less water flows through the drum.
The water level after the drum drops (with regard to
a gravity system) and a sensor that is present there
that measures the water level, subsequently, switches
the electronics. The electronics sends a signal to the
drum motor and waste pump. The drum rotates and
the rinsing pump operates the nozzles with high
pressure that clean the mesh of the rotating drum. This
wastewater is collected by a duct in the drum and flows
outside through the duct to, for example, the sewer.
After the sensor detects that the water level is
sufficient again, it switches the electronics off again.
The drum will stop turning and the pump will stop
spraying water to the nozzles.
3.2
Warning Notes
Only appropriately trained personnel may commission
and maintain this drum filter. These personnel must
be familiar with international accident prevention
regulations.
Connection and adjustment must be in
accordance with current electrical regulations.
