Ilex Filtration Biodrum 20 +31384447366
10
Subject to typesetting and printing errors
The green lights above AUT illuminate. The system is activated.
These lights must always be on! You can also turn it off by
pressing the red button (s). This is for installers only. Make
sure the green lights are always on by pressing the AUT
buttons.
Pay attention! Do not perform maintenance with the
lid off the drum. Remove the plug from the socket
and make sure that the filter cannot be switched on.
To avoid injury, make sure that your hands or
fingers cannot reach the rotating parts of the filter
when it is connected to the mains.
The system is on stand-by if the float is
floating. If the float is in the lowest
position, the process will commence
(drum starts rotating and the rinse
pump will rinse the cloth). This will last
for 14 seconds with the Makoi Drum
Control and about 20 second with the
Makoi Pond filtration Controller.
Manual flushing Ilex Controller
If you keep this button pressed, the pond
pump will stop and the motor and rinse pump
will be activated. When you release it, the
system will turn off. Then press the AUT
buttons again (green light will turn on again)
to reactivate the system (pond pump will turn
on again).
If you press the red button red button on the right, the
pond pump will be switched off
AUT light turns off.
Then press the AUT button again to turn the pond
pump back on. AUT light turns on again.
Pressing the Left Red button will turn off the pond
pump, motor and rinse pump. Always press the
AUT buttons to turn everything back on to avoid
problems.
THE GREEN LIGHTS MUST BE ON AT ALL TIMES!
OTHERWISE, THE SYSTEM IS OFF OR WILL NOT BE
RINSED! MAKE SURE YOU CHECK THIS
The float switch must be in the top position with gravity
systems (with pump fed in the bottom position) otherwise
the system will not switch on to prevent the pond pump
from running dry.
