Operating manual - English
ECODRILL 2000 C/E
25
8.2
Replacing the light bulb
To replace the light bulb:
1) turn off the master switch and remove the mains plug.
2) remove the screws (L1) which secure the glass cover (L) Fig. 22.
3) unscrew the light bulb and remove.
4) install the new light bulb and replace the glass cover with the screws (L1).
Fig. 22
8.3
Checking and replacing the fuses
The fuses should always be checked with a continuity measuring instrument (tester, ohmeter, multimeter
etc.) as a visible check may not reveal an electrical fault. Fuses must always be replaced with others of
the same type (rapid or delayed) and with the same Amps, as shown in the manual.
The ECODRILL 2000 C/E key-cutting machine has two fuses:
-
3,15 Amps rapid
placed in the inlet socket next to the master switch (fig.23), to protect the key-cutting machine from
sudden changes in voltage or short circuits.
It is advisable to check the fuses if the machine is not activated by turning on the master switch. Proceed
as follows:
1) turn off the master switch (P) and remove the mains plug.
2) remove the fuse board with the aid of a screwdriver.
Fig. 23
- 1 Amps delayed
situated on the electronic board (fig.25, page 26).
It is advisable to check the fuse when although the machine is on the display remains black.
To gain access to the fuse, follow the instructions in ch. 8.4.1, page 26 (fig.25).
L1
L
fuse board
fuses
