Ikra IAAS 40-25, Operating Instructions Manual, Page: 35 / 116

GB |
Operating Instructions
12
Cause Fault Remedy
Chainsaw does not operate The battery is empty See „Charging the rechargeable
battery“
The battery is faulty Have it replaced by our specialist
service department.
Chainsaw operates irregularly Internal loose connection Take saw to a specialty workshop
Defective on/off switch Take saw to a specialty workshop
Saw chain dry No oil in the tank Re-fill oil
Ventilation in the oil tank cap clogged Clean oil tank cap
Oil tank flow channel clogged Unclog oil flow channel
Chain/guide rail hot No oil in the tank Re-fill oil
Ventilation in the oil tank cap clogged Clean oil tank cap
Oil tank flow channel clogged Unclog oil flow channel
Dull chain Re-sharpen or replace chain
Chainsaw jumps up, vibrates or
does not saw properly
Chain tension too loose Adjust chain tension
Dull chain Re-sharpen or replace chain
Chain worn out Replace chain
Saw teeth pulling in the wrong
direction
Re-mount saw chain with
teeth in the correct direction
Fault finding
Caution!
Switch off the machine and pull out the mains plug before commencing fault finding.
The following table shows fault symptoms and describes how they can be rectified if your machine is not functioning
properly. If this does not help you localise and rectify the problem, contact your service workshop.
• If the chainsaw is not used for an extended period of
time, remove the chain oil from the tank.
• Lubricate the chain with oil.
• Slacken the saw chain after completing work because
it shortens when cooling. This prevents the chain
being damaged.
• Always replace the protective cover for transport or
storage of the chainsaw.
• Store the chainsaw in a safe and dry place and out of
the reach of children.
• When transporting the tool by car, it must be posi-
tioned so that it poses no danger, and secured.
Oiling the chain
The saw chain must be oiled before use and after clean-
ing. Only use the correct oil.