Instructions for installation and use | IKI electric heaters with Finlandia control unit Page
6
Timer
You can set the timer by pressing the menu button three times. The setting can be adjusted by pressing (
˄/+
)
and (
˅/‐
) buttons. The range is 0.5h – 24h and the interval 0.5 h. When the setting shows 0, the timer is off.
This can be changed only when the heater is off.
Switching the heater on
Use the control switch in the heater to turn the heater on. When you press the on / off button in the control
unit, the heater will begin to warm up towards the goal temperature. The heating indicator light will illuminate.
The right hand lower corner in the display will show a decimal point to indicate that the heat resistors are
switched on. (If the timer is set, pressing the on/off button will start counting down the time. The heater will
begin warming up only after the set time has elapsed.) The heater can be switched off by the on/off button.
Control switch
Tip:
If the timer has been set but the heater is not switched on yet, it is possible to bypass the timer by keeping
the on/off button pressed down for a few seconds. The heater will begin heating immediately. The timer setting
will be stored in the device's memory.
The decimal point on the right indicates that the heat resistors are
switched on. When the resistors are off, the decimal point will
disappear.
