9
3.
Line the mounting screw up with the camera’s tripod socket. Use a
coin or flat head screwdriver to tighten the Mounting Plate to the
camera.
Mounting
Plate
BOTTOM
SIDE
Mounting screw
Camera tripod
socket
FRONT
4.
Pull out on the housing control knobs to move them out of the way.
5.
Insert the Mounting Plate into the slot on the inside bottom of the
housing. Push the camera all of the way forward until the back of
the Mounting Plate is flush with the back of the housing mount.
6.
Pop up the flash before installing the camera into the housing
when triggering an external strobe. Once the camera is closed in
the housing, the flash CANNOT be raised.
Closing the Housing
1.
Make sure the o-ring is clean and in its proper location on the back
of the housing. The main o-ring does not require lubricant to make
a seal.
2.
Place the back onto the housing front.
3.
Make sure no controls or wires are interfering with the o-ring or the
back of the housing.
4.
Place each lid snap into the corresponding hook on the housing
back.
