9
2.
Check that the o-ring is in place and that the sealing surfaces are
clean. It is not necessary to lubricate the o-ring.
3.
Place the toggle lock in the open position by sliding out, flipping up,
and rotating 90 degrees counter-clockwise.
4.
Align the battery pack with the front of the strobe. The switches on
the side of the strobe and battery pack will line up when properly
oriented.
5.
Press the battery pack down gently but firmly until it is flush with the
strobe front.
6.
Press firmly on the toggle lock and rotate clockwise 90 degrees
until it stops.
7.
Flip the toggle lock down and slide in to the locked position.
Using the Diffuser
The standard diffuser may be attached to further soften and spread
the edges of the strobe’s light output. The addition of a diffuser to any
strobe or light will reduce the effective power of the light.
The standard diffuser reduces the effective guide number of the flash
by approximately one f/stop.
An optional Dome Diffuser is available separately to spread out the
light even more when shooting wide angle or macro.
Attaching the Diffuser
1.
We recommend attaching the diffuser to the strobe with a string
or lanyard using the two holes in the diffuser. This will prevent
accidental loss when not in use.
