Ikegami VFL201A, Operation Manual, Page: 14 / 42

E-4
2-4. Mounting/Removing the VFL201A to/from the Mount Attachment for UNICAM HD series cameras
■Mounting the VFL201A to the Mount Attachment
This section explains how to mount the VFL201A to the VF mounting attachment of the HDK-99. (The mounting method is the same
for other cameras.)
At first, please confirm whether the mounting hardware for VF is installed in the camera.
If there is no mounting hardware in the camera, you can’t install this VF.
1
The slide guide of VF is aligned with V shape edge of the mounting hardware for VF in the camera.
And VF is mounted on the camera by sliding it while pushing the pin for blocking the VF falling out in.
Please put the camera on a stable place and install VF to the camera.
2
Please turn VF fixing knob on the mounting hardware
in the camera clockwise and fix VF firmly.
Please operate positioning in the horizontal direction of VF
after loosening the VF fixing knob.
3
The VF connector is connected with the VF connector of the camera.
CAUTION
Please pay attention to the direction of the connector.
■ Removing VFL201A from the Mount Attachment
This section explains how to remove the VFL201A from the Mount Attachment.
Please remove the VF by the reverse procedure comparing with the mounting one.
Please put the camera on a stable place and remove VF from the camera.
2-5. Installation of microphone (mike) holder
■The mike holder installation
This section explains the method of mounting the mike holder in VFL201A
At first, the off-set metal plate is fixed at the installation part of mike holder by the special screw.
The mike holder is installed at the installation part of the off-set metal plate by the special screw which is attached with the mike
holder
Please pay attention not to lose the above special screw after removing the mike holder.
CAUTION:
MEMO:
CAUTION:
CAUTION:
CAUTION:
CAUTION:
Omission prevention knob
Fixation lever
VF ｆｉｘａｔｉｏｎ knob