Ikegami MKC-750UHD, Operation Manual

Page: 52 / 64

ڦ
Setting the master and the slave
㸯㸬
Connect SYNC connector of the CCU made a master and GENLOCK
connector of the CCU made a slave using a coaxial cable. And connect RS-
232C connector comrade using RS-232Ccross cable (D-Sub 9-pin Female).
㸰㸬
Connect the two CCU and the monitor.
ͤ
connect the both CCU output signal to the 3D-compatible monitor
ͤ
Whichever camera of the left or right is made the master, it is no
problems.
ͤ
check the Specification of the monitor for the connection of the output
of the left and right of the camera.
㸱㸬
Turn ON the main power switch.
㸦
It’s possible even from the left or right
of the CCU.
㸧
㸲㸬
From MENU, point a cursor in the order of [Video Format]
Ѝ
[Genlock]
Ѝ
[3D Support]. Therefore, change the camera setting in ’Master’ in the case
of Master, and in ’Slave’ in the case of the Slave.
Video Format
㻌
Frame Rate 59.94Hz
㻌
SDI Output 1080i
㻌
DVI Output 1080p
㻌
H Position 0
㻌
V Position 0
㻌
Genlock AUTO
㻌
Center Marker OFF
㻌
㻌
㻌
Video Format
Ѝ
Genlock
㻌
H Phase 0
V Phase 0
㻌
3D Support SLAVE
㻌
㻌