15
EN
IMPORTANT
Before starting a cycle, run hot water to
clear cool water from pipe.
Water Pressure
The hot water line to dishwasher must
provide water pressure between 20 and 120
psi.
Low water pressure may occur when
laundry or showers are in operation. If you
experience poor wash performance you
may need to wait until water use is reduced
before starting the dishwasher.
How to adjust the rinse aid
dosage
Press and hold the RINSE ONLY and DELAY
START button for 5 seconds until the status
window shows rinse aid level. Pressing
the DELAY START button increases the
increment level (L0-L6).
Once the rinse-aid level reaches L6, the
status window will start back at level L0.
Pressing the START button or just pausing
for a few seconds confirms the rinse aid
level setting: the status window shows the
duration of the cycle.
Water Temperature
Hot water is needed for best dishwashing
and drying results. Water entering
dishwasher should be at least 120°F (49°C)
to give satisfactory results.
To check water temperature entering
dishwasher:
• Turn on hot water faucet nearest
dishwasher for several minutes to clear
cool water from pipes.
• Hold a candy or meat thermometer
in the water stream to check the
temperature.
•
If temperature is below 120°F (49°C),
have a qualified person raise the hot
water heater thermostat setting.
Indicator
Rinse Aid
Compart-
ment
Rinse Aid
Cover
Rinse Aid
Rinse aid greatly improves drying,
reduces water spots, filming.
With
it water “sheets” off dishes rather than
forming water droplets that cling and leave
spots.
A dispenser, located next to the detergent
cup, automatically releases a measured
amount of rinse aid during the last rinse.
If spotting and poor drying are problems,
increase the amount of rinse aid dispensed.
The indicator will be dark when full and will
show clear when it is time to refill.
To add liquid rinse aid:
1. Lift up the rinse aid cover to open.
2. Fill the rinse aid dispenser with liquid
rinse aid until the liquid reaches the
indicated fill level. DO NOT overfill.
3.
Press the rinse aid cover down firmly to
close.
4. Wipe up any spills with a damp cloth.
The dispenser holds enough for 11 to 66
washes, depending on setting.
NOTE
The HEAT DRY option in combination with
rinse aid will enhance drying performance.
The energy required to use the HEAT DRY
option costs pennies per cycle. You may
choose not to select the HEAT DRY option;
however you will have items in your dish
load that will not be completely dry at the
end of the cycle.
OPERATING INSTRUCTIONS
