10
Set the timer to 00:00 [min:sec] by rotating the "Start/Stop" knob (K).
The counter function is activated and counter indicator (E) lights up.
Start the device by pressing the "Start/Stop" knob (K).
Refer to the operating instructions for the filling level of the
medium and the immersion depth into the dispersion tool
used.
If a dispersion tool is not inserted into the drive flange as far
as the mark it can become extremely hot in operation and
thus suffer damage.
So as to avoid unintentional ingress of air into the medium
due to excessively turbulent rotation, the whole unit can be
placed a little off center in the dispersing vessel.
Commissioning and operating
Check whether the voltage given on the type plate corre-
sponds to the available power voltage.
The socket used must be earthed (fitted
with earth contact).
If these conditions have been met, the machine is ready to
operate when the power plug is plugged in.
If these conditions are not met, safe operation is not guar-
anteed and the machine could be damaged.
Activate the device by pressing on/off button (L).
After a beep,
the "Speed" setting indicator (P) lights up.
Change the speed setting by rotating the "Start/Stop" knob (K).
The speed value shows on the display (A), e.g.:
means the speed is 3200 (3.2 x 1000) rpm.
Start the device by pressing the "Start/Stop" knob (K).
Note:
After starting,
actual speed value flashes until reach the set value.
Setting speed:
Switching on:
After switching on the power switch (8) of the device, all LED segments light up during self test.
Then, "Timer" display (B) shows the software version.
After that, the device enters standby status and "Speed" setting indicator (P) keeps lighting.
Setting timer:
Activate the timer setting by pressing timer button (M).
Timer setting indicator (O) lights up.
Change the timer setting by rotating the "Start/Stop" knob (K).
When the timer is set to over 00:00, the timer function is activated and timer indicator (D)
lights up.
The "min: sec" indicator (N) and "h:min" indicator (C) show the unit of the timer value.
Start the device by pressing the "Start/Stop" knob (K).
When the time reach 00:00, the device stops running and the display (A) and (B) show last
settings.
Note:
While running, the timer setting can be checked by pressing the timer button (K).
Activating the counter function:
