15
Page
Declaration of conformity
3
Safety instructions
15
Unpacking
17
Correct use
17
Assembling the stand
17
Operation
18
Setting operation mode
19
Er 5
19
Setting the safe temperature limit
20
Controlling the Medium temperature limit via
21
ETS-D or Contact Thermometer
Setting the temperature control mode
22
Maintenance
22
Accessories
22
Error codes
23
Technical Data
24
Warranty
25
For your protection
• Read the operation instructions in full before starting up
and follow the safety instructions.
• Keep the operation instructions in a place where they can be
accessed by everyone.
• Ensure that only trained staff work with the appliance.
• Follow the safety instructions, guidelines, occupational health
and safety and accident prevention regulations.
• Socket must be earthed (protective ground contact).
Before starting the device for the first time, ensure that the con-
nector cable is suitable for the type of socket used and that a
safe protective earth connection is assured.
•
Caution - Magnetism!
Effects of the magnetic field have to be
taken into account (e.g. data storage media, cardiac pacemakers ...).
• Risk of burns! Exercise caution when touching the housing parts
and the heating plate. The heating plate can reach temperatu-
res in excess of 310 °C. Pay attention to the residual heat after
switching off.
• Ensure that the mains power supply cable does not touch the
heating base plate.
• Wear your personal protective equipment in accordance with
the hazard category of the media to be processed. Otherwise
there is a risk from:
- splashing and evaporation of liquids
- ejection of parts
- release of toxic or combustible gases.
• Set up the appliance in a spacious area on an even, stable,
clean, non-slip, dry and fireproof surface.
• The feet of the appliance must be clean and undamaged.
• Check the appliance and accessories beforehand for damage
each time you use them. Do not use damaged components.
• Gradually increase the speed.
• Reduce the speed if:
- the medium splashes out of the vessel because the speed is
too high
- the appliance is not running smoothly
- the container moves on the base plate.
•
Caution!
Only process and heat up any media that has a flash
point higher than the adjusted safe temperature limit that has
been set (50 to 360 °C).
The safe temperature limit must always be set to at least 25 °C
lower than the fire point of the media used.
Contents
Safety instructions
Source language: German
EN
