19
Unpacking
/// Unpacking
• Please unpack the device carefully
• In the case of any damage a detailed report must be sent
immediately (post, rail or forwarder)
/// Scope of delivery
• Heating magnetic stirrer
• Mains cable
• Operating instructions
• Screwdriver
• Protective cover
• Temperature sensor PT 1000
/// Use
• The magnetic stirrer is suitable for mixing and / or heating subs-
tances.
/// Area of use
• Indoor environments similar to that a laboratory of research,
teaching, trade or industry area.
• The safety of the user cannot be guaranteed:
- if the device is operated with accessories that are not supplied
or recommended by the manufacturer,
- if the device is operated improperly or contrary to the
manufacture’s specifications,
- if the device or the printed circuit board are modified by third
parties.
Intended use
Assembling the stand
Note:
When using bath attachments
with a diameter over 180 mm, please
use support rod in conjunction with an
extension. (See “
Accessories
”)
• Remove screw plugs (M).
• Remove the protective cap from the support rod.
• Put the washer between housing and nut.
• Screw the support rod onto the device
by hand until the end stop is reached.
• Use an A/f 17 spanner to tighten the
M10 nut.
• Accessories should be attached using
cross sleeves.
Risk of tipping!
Make sure that the center of mass of the
attached device does not protrude over
the safe area indicated with a dashed
rectangle.
safe area
Summary of Contents for RCT basic safety control
Page 2: ...2 M J F B A K D C E I H G L ...
Page 139: ......
