•
A seperation from the line is made with the equipment only by
pulling net and/or device plug.
•
Safe operation is only guaranteed with the accessories described
in the ”Accessories” chapter.
•
Always disconnect the plug before fitting accessories.
•
Accessories must be securely attached to the device and cannot
come off by themselves. The centre of gravity of the assembly
must lie within the the set-up surface.
•
The appliance starts up again automatically following a cut in the
power supply.
•
The appliance may heat up when in use.
•
Abrasion of the dispersion equipment or the rotating accessories
can get into the medium you are working on.
To the protection of the equipment
•
The voltage stated on the nameplate must correspond to the
mains voltage.
•
Do not cover the device, even partially e.g. with metallic plates or
film. This results in overheating.
•
Protect the appliance and accessories from bumps and impacts.
•
Observe the minimum distances between devices, between the
device and the wall and above the assembly (min. 100 mm).
4
072010
•
Unpack
- Please unpack the device carefully
- In the case of any damage a fact report must be set
immediately (post, rail or forwarder)
•
Delivery scope
- Heating magnetic stirrer
or
Magnetic stirrer
or
Heating device
- Mains cable
- Operating instructions
•
Use
-
For mixing and/or heating liquids
•
Range of use
- Laboratories
- Schools
- Chemical industry
- Pharmacies
Unpack
Correct use
> 100 mm
> 100 mm
> 100 mm
•
Avoid large, sudden changes of temperature. A thermal
shock can lead to cracking of the ceramic coating.
3582825_C-MAG_112010:35 828 25 10/19/2011 9:59 AM Page 4
