3
072010
Page
Safety instructions
3
Unpack
4
Correct use
4
Commissioning
5
Error codes
6
Accessories
6
Maintenance
6
Warranty
7
Technical data
8
To your protection
• Read the operating instructions in full before starting up
and follow the safety instructions.
•
Keep the operating instructions in a place where they can be
accessed by everyone.
•
Ensure that only trained staff work with the appliance.
•
Follow the safety instructions, guidelines, occupational health
and safety and accident prevention regulations.
•
Socket must be earthed (protective ground contact).
• Attention - Magnetism!
Effects of the magnetic field have
to be taken into account (e.g. data cardiatic, carriers pacema-
kers...).
• Risk of burns!
The heating plate temperature can exceed
500 °C. Pay attention to the residual heat after switching off.
Please make sure that the mains cable does not contact the
heating plate
•
Wear your personal protective equipment in accordance with the
hazard category of the medium to be processed. Otherwise
there is a risk of:
- splashing liquids
- projectile parts
- release any toxic or combustable gases.
•
Set up the appliance in a spacious area on an even, stable, clean,
non-slip, dry and fireproof surface.
•
The feet of the appliance must be clean and undamaged.
•
Position the knob at the left stop before starting up. Gradually
increase the speed.
•
Reduce the speed if
- the medium splashes out of the vessel because the speed is too high
- the appliance is not running smoothly
- the container moves on the set-up surface.
•
Never heat up any medium with fire point lower (min. 50°C)
than the adjusted temperature
•
When using PTFE-coated magnetic bars, the following hase
to be noted:
Chemical reactions of PTFE occur in contact with
molten or dissolved alkaline and alkaline - earth metals, as well
as with fine-particled powders of metals of the 2. and 3. group
of the periodical system at temperatures above 300-400°C.
Only elementary fluorine, chlorine trifluoride und alkaline metals
do attack PTFE, halogen hydrocarbons have a reversibly swelling
effect.
•
Check the appliance and accessories beforehand for damage
each time you use them. Do not use damaged components.
•
Only replace damaged parts with spare parts identical to the ori
ginal in function and quality.
•
Do not use the device if the ceramic set-up surface is damaged
e.g. scratches, splinters or corrosion. A damaged set-up surface
could break if used.
•
Beware of the risk of
- flammable materials
- glass breakage as a result of mechanical shaking power
- incorrect container size
- too much medium
- unsafe condition of container
•
Only process media that will not react dangerously to the extra
energy produced through processing. This also applies to any
extra energy produced in other ways, e.g. through light irradiation.
• Do not
operate the appliance in explosive atmospheres, with
hazardous substances or under water.
Contents
Safety instructions
EN
3582825_C-MAG_072010:35 828 25 7/12/2010 4:03 PM 页 3
