ENGLISH
CONNECTING YOUR MONITOR : ProLite H481S
[Example of Connection]
A
Ensure that both the computer and the monitor are switched off.
B
Connect the computer to the monitor with the signal cable. (See page 36 for CONNECTOR PIN
ASSIGNMENT.)
C
Connect the monitor to the audio equipment with the Audio Cable when using the audio features.
D
Connect the Power Cable to the monitor first and then to the power supply.
NOTE
The signal cables used for connecting the computer and monitor may vary with the type of
computer used. An incorrect connection may cause serious damage to both the monitor and
the computer. The cable supplied with the monitor is for a standard 15 pin D-Sub connector.
If a special cable is required please contact your local iiyama dealer or regional iiyama office.
For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama office for a suitable adaptor.
Make sure you tighten the finger screws at each end of the signal cable.
<Back>
AC IN
LINE
D-SUB
DVI-D
OUT
IN
Power Cable
(Accessory)
Audio Cable (Accessory)
Computer
D-Sub Signal Cable
(Accessory)
DVI-D Signal Cable
(Accessory)
[ Installation of cable cover ]
A
Collect cables at the back of the stand.
B
Inserting the tabs of the cable cover into guide
holes of the stand.(
B
)
C
Place the cable cover by inserting the tabs of
the cable cover into guide holes of the
stand.(
C
)
[ Uninstallation of cable cover ]
A
Push the both sides and tilt back the cable cover.
BEFORE YOU OPERATE THE MONITOR 11
