Iiyama ProLite B2282HD, User Manual

Page: 15 / 33

ENGLISH
BEFORE YOU OPERATE THE MONITOR 11
CONNECTING YOUR MONITOR : ProLite E2282HD
Ensure that both the computer and the monitor are switched off.
Connect the computer to the monitor with the signal cable.
Connect the Power Cable to the monitor
fi rst and then to the power supply.
Turn on your monitor and computer.
[Example of Connection]
<Back>
NOTE

The signal cables used for connecting the computer and monitor may vary with the
type of computer used. An incorrect connection may cause serious damage to both
the monitor and the computer. The cable supplied with the monitor is for a standard
connector. If a special cable is required please contact your local iiyama dealer or
regional iiyama of
fi ce.
 For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama of fi ce for a suitable adaptor.
 Make sure you tighten the fi nger screws at each end of the signal cable.
 The Class I pluggable equipment Type A must be connected to protective earth.

The socket-outlet shall be installed near the equipment and shall be easily accessible.
* VGA (D-Sub) cable is not supplied with the monitor; you need to use a special VGA (D-Sub) cable
dedicated for this model. Please contact the iiyama Support Centre in your country if you wish to
connect the monitor via the VGA input.
Power Cable
(Accessory)
Computer
VGA(D-sub) Signal Cable*
(Not Included)
DVI-D Cable (Accessory)