K238 Media- / DVI-Converter
36
2011-02-23
6.1.1
Optimization of Output Settings
1. If you have an analog input signal, display a picture with as much
detail as possible on your graphic source, e.g. a text with black letters
on a white ground (or vice versa).
2. Open the OSD with the infrared remote control.
3. Select 'Output Settings' in the main menu (see Chapter 5.2.4,
Page 30).
4. Select the output resolution in the menu item 'Output':
–
Select 'DDC' to use the preferred resolution of the monitor DDC.
–
If the preferred resolution of the device DDC does not result in a
satisfying picture, select 'Factory' and from the menu item
'Resolution' the most suitable resolution for the monitor.
5. Exit the OSD.
A window appears to save settings. This may take a few seconds.
6. Save the settings.
6.1.2
Optimization of Input Settings
For certain analog input signals (VGA / RGB / EGA), if the picture quality
is not satisfying or no picture is displayed, you can select a video mode
depending on the input signal.
1. Open the OSD with the infrared remote control.
2. Select 'Input Settings' in the main menu (see Chapter 5.2.3, Page 29).
3. Test the recommended resolutions that are listed in the menu item
'Select Resolution'. The menu item is inactive, if there is only one
recommended resolution.
4. Run the automatic picture adjustment:
–
Select 'Picture Settings' in the main menu (see Chapter 5.2.2,
Seite 26).
–
Select the menu item 'Auto Configuration'. Thereby picture size
might change.
5. Check the test picture: If the vertical lines are displayed clearly,
without smear or tremble, the setting has been successful.
6. Exit the OSD.
A window appears to save settings. This can take a few seconds.
7. Save the settings.
