Setting Up the iP39
4
Setting the Clock
Setting the Time and Calendar using iPhone/iPod Time Sync
Time sync mode allows you to sync the iP39 to the time and calendar from your iPhone or recent models of iPod like iPod
Touch, iPod Nano and iPod Classic (older models such as iPod Mini do not support this feature).
1. Make sure your iPhone or iPod is properly docked. Press the
time sync/time set Button
located at the back of the unit.
“SYNC” will appear on the display, indicating sync function is in progrress.
2. After sync is complete, the display will show the current time and date on your iPhone/iPod clock and two beeps will
confirm time sync is done.
3. If time sync fails, 2 second long beep sounds and the unit exits time sync mode. Try syncing agin, or set time and calendar
manually (see below).
NOTE
: The iPhone is constantly updated to current time via cell phone towers. The time on your iPod is only accurate to
the last time it was synced to a computer. It’s possible to have up to 59 seconds difference between the iP39 and synced
iPhone/iPod.
Setting Time and Calendar Manually
1. Set
the
DST Switch
located on the back of the unit to +1 to add one hour or to -1 to subtract an hour to account for
daylight saving time or standard time
2. Press and hold the
time sync/time set Button
located at the back of the unit until the time display flashes.
Press the
or
button
to set the correct time (press and hold for rapid advance). Remember to set the correct AM
or PM tme. The
PM Indicator
is located to the upper left side of the time digits; there is no AM indicator.
3. Press the
Alarm Button
at any time during clock setting to toggle the display between 24 hour (military) and 12 hour
(standard) display mode.
4. Press
the
time sync/time set Button
. The year will flash. Press the
or
button
to set the current year.
5. Press the
time sync/time set Button
. The date will flash. Press the
or
button
to select the current date (press
and hold to enter fast scroll mode). The correct day will appear for the date set.
6. Press
the
time sync/time set
again (or no button press within 10 seconds) to exit the clock setting mode.
iP39 has 2 independent timers, a
quick timer
that lets you quickly set the timer in 1 minute steps and
Timer 2
, a normal
timer which can be set in 5 minute increments. Both timers can run at the same time.
Setting the timers
1. Press
the
quick timer/+1 min button
or the
timer 2/ +5 min button
to set the desired timer. Its icon and the timer digits
will flash. Use the table below to set the desired countdown time in either timer mode while digits are flashing:
Timer Operation
April 19, 2010
ACTION
Press
Press
Hold
Hold
Hold
Press
Press
Press
BUTTON
OFF
quick timer + 1 min
+ 1 minute each press
+/– 1 minute each press
+/– 1 second each press
rapid /– minutes
rapid /– seconds
Cancel/end timer
+ 5 minute each press
+ 1 hour each second held
quick timer
or
timer 2
timer 2 + 5 min
RESULT
