IHI Shibaura SR525HP-S, Operator'S Manual

Page: 144 / 154

62
Section 9 Periodical inspections and services
15. Inspecting and replacing the
fuse and fusible link
Remove the fuse box cover and inspect the fuse.
If the fuse has blown out, replace with the one
with the specified capacity.
Stop the engine and inspect the fusible link. The
fusible link is a type of fuse. If excessive current
flows to the wiring circuit (circuit to which the
power is usually flowing), the fusible link melts
and shuts off the current. If the fusible link has
melted, the outer sheathing (vinyl) is discolored.
In such a case, have your dealer inspect it.
16. Inspecting the tire
①
Inspecting the tire
Check if the tire air pressure of front and rear
wheels is proper.
You can judge it from the appearance as shown
below.
Standard air pressure
Tire size
Air pressure
kPa (kgf/cm
2
)
Front wheel 24
×
13.00-12 88 (0.9)
Rear wheel
20
×
10.00-10
98 (1.0)
Check the tire for damages and cracks.
②
Inspecting the wheel installing bolt
Check each wheel installing bolt for looseness. If
any bolt is loosened, retighten it according to the
list below.
Wheel Tightening torque Nm (kgf·cm)
Front wheel 13±216Nm (1400±160kgf·cm)
Rear wheel 50±5.9Nm (500±60kgf·cm)
17. Color of exhaust gas
When the engine is started, color of the exhaust
gas is blackish. It is usually colorless.
Black ···· Incomplete combustion due to too rich
fuel
White ··· Engine oil is burning. However, when
the atmospheric temperature is low, the
color may look white because of the
vapor.
If the exhaust gas is black or white even while no
load is applied, have the dealer service the
machine.
65
9