20
Disassembly of the cocking side:
a) Take off the wind-lever 370.01 U11 and pawl carrier 370.01 U8 (Pay attention to the wind-
lever return spring 370.01-110). [The circlip may have formed burrs on the top of its
groove. Dress them with a needle file so that the pawl-carrier slides off easily]
b) Remove the locking wheel 370.01 U6 and shims 370.01-87/1. [One above, one below]
c) Remove the circlips 1.5 DIN 6799, the cocking spindle 370.04 U6 and the transport spindle
370.04 U7. Both spindles come out downwards (note shims).
d) Undo the 4 fixing screws 300.21-59 for the intermediate plate 370.04 U4, and lift off the
intermediate plate.
Assembly of the cocking side:
As described under C.1.a) to C.1.d) but in reverse order (take care to replace shims).
2. Cocking segment 370.07 U5 is damaged.
Dismantle camera, as under Disassembly of Camera A.1 to A.3.
a) Mark the position of both curtain-rods in the un-cocked condition on the shutter plate
(right), and the mesh of the teeth of both pinions 370.03-27 with the shutter wheels, 370.07
U7 and 370.07 U8.
b) Remove the two pinions 370.03_27.
c) Undo and remove all the fixing screws for the right shutter-plate (4 screws) and for the
shutter cover-plate 370.03 U14 (1screw) (see Fig2) as well as for the right cover-plate
370.03-24 (3 screws) [inside]. Remove the shutter plate, springing the shutter cover-plate
backwards.
